Home > Discussion Groups > Tricks & Tips

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

Advertisement
 Return to Index  

Another method

June 23 2008 at 11:08 AM
  (Login djnick66)
Missing-Lynx members
from IP address 71.100.202.217


Response to Re: How about.......

Im not sure a hot iron will do much to a thick resin tire. I would saw the tire flat, making sure to keep the bottom at the proper angle. If the vehicle has a flat tire it might lean a bit... then build up the flat bulgey part around teh bottom with some epoxy putty.

 
 Respond to this message   


Terms and Conditions of Use
Report abuse